The Following F.A.Qs Will Help You Order The Precise Part For Your Hot Rod.
Q-Does your car have original steel fenders?
D- Answer NO if fiberglass
Q- Does your car have steel fenders?
D- If you answer YES, By default, this bra requires 2 snaps to be installed. 1 on the underside of each
fender, in the fender lip/fender roll edging. Using a 1/8" drill bit, make a small hole. Then tighten in the
provided 3/8" stainless screw stud. The female side is installed in the bra. Fold the bra around the
fender and snap together. If you answer NO, bra will automatically come with the top outside tab being
a bendable velcro tab.
Answer NO if you've reinforced your fenders and cannot install the snap. Note:
This question only applies to a handle full of our bras. Not applicable on every model.
Q- Does your fender brace come all the way out to the edge of the fender?
D- Answer YES if applicable. Answer No, your bra will automatically come with the top outside tab being
a bendable velcro tab. Reason being to keep the bra from slipping down due to no fender brace that
comes all the way out the edge of the fender.
READ MORE OF THE F.A.Q.S